Dodge 2010 Nitro Manuel d'utilisateur télécharger pdf (Page 170)

100

101

Gate Operator/Canadian Programming

Canadian radio-frequency laws require transmitter sig-

nals to “time-out” (or quit) after several seconds of

transmission – which may not be long enough for

HomeLink威 to pick up the signal during programming.

Similar to this Canadian law, some U.S. gate operators are

designed to “time-out” in the same manner.

It may be helpful to unplug the device during the cycling

process to prevent possible overheating of the garage

door or gate motor.

If you are having difficulties programming a garage door

opener or a gate operator, replace “Programming

HomeLink威” Step 3 with the following:

3. Continue to press and hold the HomeLink威 button,

while you press and release (“cycle”), your handheld

transmitter every two seconds until HomeLink威 has

successfully accepted the frequency signal. The indica-

tor light will flash slowly and then rapidly when fully

trained.

If you unplugged the device for training, plug it back in

at this time.

Then proceed with Step 4 under “Programming

HomeLink威” earlier in this section.

Using HomeLink姞

To operate, press and release the programmed

HomeLink威 button. Activation will now occur for the

trained device (i.e., garage door opener, gate operator,

Security system, entry door lock, home/office lighting,

etc.,). The handheld transmitter of the device may also be

used at any time.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 497 498

Commentaires sur ces manuels

Pas de commentaire

Dodge 2010 Nitro Manuel d'utilisateur Page 170

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Dodge 2010 Nitro