Dodge 2009 Caliber Manuel d'utilisateur télécharger pdf (Page 142)

100

101

Place the hand-held transmitter 1–3 in (3-8 cm) away

from the HomeLink威 button you wish to program while

keeping the indicator light in view.

3. Simultaneously press and hold both the chosen

HomeLink威 button and the hand-held transmitter button

until the HomeLink威 indicator changes from a slow to a

rapidly blinking light, then release both the HomeLink威

and hand-held transmitter buttons.

Watch for the HomeLink威 indicator to change flash rates.

When it changes, it is programmed. It may take up to

30 seconds, or longer in rare cases. The garage door may

open and close while you train.

NOTE:

•

Some gate operators and garage door openers may

require you to replace Step 3 with procedures noted in

the “Gate Operator/Canadian Programming” section.

•

After training a HomeLink威 channel, if the garage

door does not operate with HomeLink威 and the ga-

rage door opener was manufactured after 1995, the

garage door opener may have a rolling code. If so,

proceed to the heading “Programming ARolling Code

System.”

4. Press and hold the just-trained HomeLink威 button

and observe the indicator light.

If the indicator light stays on constantly, programming is

complete and the garage door (or device) should activate

when the HomeLink威 button is pressed.

If the indicator light blinks rapidly for two seconds, and

then turns to a constant light, continue with program-

ming for a Rolling Code.

5. PROGRAMMING A ROLLING CODE SYSTEM

At the garage door opener motor (in the garage), locate

the “Learn” or “Training” button.

140 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 430 431

Commentaires sur ces manuels

Pas de commentaire

Dodge 2009 Caliber Manuel d'utilisateur Page 142

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Dodge 2009 Caliber